On how to solve the linear PET automatic bottle blowing machine thread mouth deformation method:
Linear PET full-automatic bottle blowing machine in the bottle blowing, there may be a good bottle screw deformation, cap cap does not go up, or after the cap leakage, the main reasons are two;
One is that the temperature of the lowest layer of the lamp tube is too high, resulting in heat, deformation of the preform thread mouth, this is relatively simple, the appropriate temperature can be reduced
Two is that the mold is not installed in place, resulting in mold and bottle blank dislocation, a mold will be a screw mouth clamping bad, this is about the master patience to adjust the mold center can
The deformation of the screw mouth of the bottle blank is nothing more than the above situation, and that is, one and two appear at the same time, so it needs to adjust two first, and then adjust one.
Related Industry Knowledge
- Automatic bottle blowing machine development trend
- Bottle blowing machine how to choose?
- Automatic bottle blowing machine advantages
- Automatic bottle blowing machine features
- Basic knowledge of blow molding machine science
- Blow molding machine classification
- Hollow blow molding machine / blow molding proc...
- Competition white-hot blow molding machine indu...
- Technical Features Analysis of PP Blow Molding ...
- The working principle of blow molding machine
- Full electric bottle blowing machine